Linux NFS Configurations

From RCSWiki

The RCS Lab currently uses Linux 2.6 kernel released by Xilinx (Xilinx Git Repository). We have in the past used Grant Likely's SecretLab; however, he appears to be having server troubles and has not posted updates for over a month (Last Checked: April 17, 2008).

NOTE: These directions assume you are using a Xilinx ML-410; however, it is possible with minimal modifications to target the ML-310 or other development boards.

Directions:

1. If you have not already done so, download Latest Xilinx Linux Kernel
   • git clone git://git.xilinx.com/linux-2.6-xlnx.git
2. Change directories into linux-2.6-xlnx directory
3. Setup the Default ML-403 Configuration
   • Yes, ML-403 is correct, even though we use ML-410
   • You will type this every time you want to use the "make" command with Linux:
     • make ARCH=ppc CROSS_COMPILE=powerpc-405-linux-gnu- <COMMAND>
     • ARCH=ppc sets the Architecture to PowerPC (ppc405 on FPGA)
     • CROSS_COMPILE set which Cross Compiler to use
       • We use CrossTools to build version gcc-4.2.1-glibc-2.3.6
       • You can source the CrossTools by: source /opt/crosstool/settings.sh
     • <COMMAND> Specify which command to run make on
       • dl403_defconfig setup Linux configuration to start with ML-403 Setttings
       • menuconfig Open menu to custom configurations
       • zImage Compile Linux Kernel to zImage.elf
4. So start with ml403_defconfig
   • make ARCH=ppc CROSS_COMPILE=powerpc-405-linux-gnu- ml403_defconfig
5. Then make the next changes in the Menu
   • make ARCH=ppc CROSS_COMPILE=powerpc-405-linux-gnu- menuconfig
6. Menu Configuration Changes (Depending on Situation you may make more / less)
   • Platform Options:
     • Change console=ttySO to: console=ttyUL0, root=/dev/nfs nfsroot=192.168.1.101:/export/rootfs/n01 ip=dhcp
   • Device Drivers:
     • Network Device Support:
       • 'N' - Ethernet (10 or 100Mbit)
       • 'Y' - Ethernet (1000 Mbit):
         • 'Y' - Xilinx LLTEMAC 10/100/1000 Ethernet MAC driver
         • MARVELL 88E1111 using MII or other PHY
       • 'N' - Ethernet (10000 Mbit)
     • Character Devices:
       • Serial Drivers:
         • 'N' - 8250/16550 Compatible Serial Support
         • 'Y' - Xilinx uartlite serial port support
         • 'Y' - Support for console Xilinx uartlite serial port
7. Make sure the xparameters_ml40x.h from Hardware Base System is copied to:
   • linux-2.6-xlnx/arch/ppc/platform/4xx/xparameters/xparameters_ml403.h
8. Compile the Linux Kernel
   • make ARCH=ppc CROSS_COMPILE=powerpc-405-linux-gnu- zImage

At this point you should have a file called zImage.elf in linux-2.6-xlnx/arch/ppc/boot/images which will be combined with the hardware's download.bit to create an ACE file.

Continue on to the Combining Linux 2.6 with Hardware Base System Tutorial